Yeah, I’m not sure what would make a case obsolete other than not physically fitting your hardware. I’m using a janky mid-2000s Antec case to hold my i7-9700k / RTX 2070 build with no problems (although I fully expect to need a bigger case for any future GPU upgrades).
My hot take is that this is practically irrelevant for the vast majority of desktop users, even hobbyists. Unless you have an absolute rats’ nest of cables inside the case or you are overclocking the chip close to its thermal limits, your chip should run just fine with a small form factor heatsink/fan, which an older, non-enthusiast case should have no problem fitting. As one data point, I’m cooling my CPU with a Noctua NH-D15 inside my Antec Three Hundred. A somewhat tight fit? Maybe, but certainly no performance issues.
Far from being a tech wizz, I once decided I was going to push to the absolute limits an old 775 board I had around and the only concern I had was with CPU cooling, as I intended to fit the machine with a Core2 Quad.
Because the machine was built inside an SFF, putting in a larger cooler was not feaseable, unless I was to cut a hole into the side panel to accomodate it. However, spending a few more monies on the CPU for a 65W model did the trick and I managed to keep the stock cooler I was already using.
As long as the GPU and PSU fit, I don’t see why you couldn’t use it!
Yeah, I’m not sure what would make a case obsolete other than not physically fitting your hardware. I’m using a janky mid-2000s Antec case to hold my i7-9700k / RTX 2070 build with no problems (although I fully expect to need a bigger case for any future GPU upgrades).
deleted by creator
My hot take is that this is practically irrelevant for the vast majority of desktop users, even hobbyists. Unless you have an absolute rats’ nest of cables inside the case or you are overclocking the chip close to its thermal limits, your chip should run just fine with a small form factor heatsink/fan, which an older, non-enthusiast case should have no problem fitting. As one data point, I’m cooling my CPU with a Noctua NH-D15 inside my Antec Three Hundred. A somewhat tight fit? Maybe, but certainly no performance issues.
deleted by creator
Far from being a tech wizz, I once decided I was going to push to the absolute limits an old 775 board I had around and the only concern I had was with CPU cooling, as I intended to fit the machine with a Core2 Quad.
Because the machine was built inside an SFF, putting in a larger cooler was not feaseable, unless I was to cut a hole into the side panel to accomodate it. However, spending a few more monies on the CPU for a 65W model did the trick and I managed to keep the stock cooler I was already using.
Ancient front panel IO, but as long as you have good mobo IO, it isn’t terribly important anyways.