Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • @Tarnaq@lemmy.worldOPEnglish
    10•7 months ago

    It may be because I paused the print to check raft adhesion. I’ll try some prints tomorrow without pausing.

    • BoozillaEnglish
      9•7 months ago

      Pausing a print usually causes me problems. I’m not sure why. Temperature, maybe.

      • @Tarnaq@lemmy.worldOPEnglish
        3•7 months ago

        That’s what I’m beginning to suspect, other prints that have had ridges or offsets I paused as well.

    • @AmieFromEarth@lemmy.worldEnglish
      2•7 months ago

      Im pretty sure that you have that issue cause of the pausing then. I paused a print once, during one of my first prints, and after resuming it failed. So i just made it a thing to never pause prints again. It just messes with the print for some reason.