I have always wanted to try printing larger, using a bigger nozzle - just got around to swapping to a .6mm in my MK3S+. Printed a gift for a childhood friend. 300% size. Took just under 10 hrs. With the slicer settings on .4mm it was over 17hrs.

  • @AuroraBorealis
    link
    English
    27 months ago

    How did that print so well without any supports?

    • Thanks4NothingOP
      link
      fedilink
      English
      17 months ago

      That is a very good question. There aren’t any insane overhangs, just a few tricky spots. I had print he same thing smaller, so I knew it would be okay. I think the file actually mentioned in the notes that you COULD print it without support.

      • @Contend6248@feddit.de
        link
        fedilink
        English
        17 months ago

        I was shocked too at first, but then i realized the same thing, i don’t see anything problematic, what a great model

        • Thanks4NothingOP
          link
          fedilink
          English
          27 months ago

          I had to dig to find where I got the model from. I suppose I should add the link in case anybody wants to give them kudos or print it for themselves.

          It was created by Rocket Pig Games: Printables link