cross-posted from: https://sopuli.xyz/post/9204474

I had been looking for a bike to get around my local city and managed to snag a Huffy cruiser for $50. It is in decent shape with only some superficial rust on the pedals. This will be a big learning experience for me as I haven’t ridden a bike for nine years. I’ll both learn how to use a bike to run errands and how to do some of my own maintenance. Maybe even customize it a bit by adding a frame lock and a 3 speed gear hub. I guess we shall see how far I get in this learning and fitness quest.

  • @Menagerie
    link
    English
    24 months ago

    Pro-tip: These bikes usually come with little to no grease in the bottom bracket, headset, and front hub. I would recommend overhauling them sooner rather than later if you want the bearings to last.

      • @Menagerie
        link
        English
        34 months ago

        Overhaul as in pull the bearings out, clean them with degreaser, then inspect them. If the bearings are not pitted and the retainer isn’t bent out of shape, you can reuse them. If they are messed up, they are very cheap to replace, many bike shops will have replacements on hand. Once you have cleaned or gotten new bearings, pack the cups they sit in full of grease, and reassemble. Typically bearing retainers will have a side that is more rounded and a side that is more flat, you usually want to put them into the cup rounded side facing in.

        Once you have it back together, you want to adjust it. The goal is to have the bearings be as loose as possible while not having any play in them. You also want to make sure the locknut is tight against the cone.

        This page has info that will be useful for the bottom bracket.