I have no clue what could have gone wrong as it was working fine last night but now it’s doing this. Any solution other than data recovery and a new hard drive ?
Haven’t heard of a drive beep unless it has a speaker in it. if it does check the manual for what the beep codes are.
If the noise is more like a metal tick or knock noise, that indicates mechanical failure and that is a very bad sign.
I’ve heard of drives ‘beeping’ before, and it’s not from a beeping speaker. This happens when the heads are stuck to the platters while the controller board is trying to move the head actuator arm.
When the heads get stuck like that, the voice coils of the actuator arm end up resonating high frequency sound much like a speaker.
The condition isn’t good, that’s for sure. I’ve seen where stuck heads can sometimes be unstuck by putting the drive in the freezer overnight, then plugging it up while still totally frozen.
But that trick doesn’t always work, and sometimes it requires a little external force like tapping the corners of the drive on a desk to help free it up.
Or pay a data recovery center a butt load of money to open the drive up and salvage the data, either way is a compromise and the drive shouldn’t be considered reliable even if the heads are freed up.
Thanks for the help sad to see it isn’t good news but at least I got a idea of what’s up
If the drive is in an enclosure there’s a slim chance the enclosure is what failed. More likely though it’s a hardware failure.
Seagate makes a utility called SeaTools for running diagnostics on drives.
Time to contact Seagate customer support
I’ve ordered a new hard drive and have the same problem and my PC refuses to boot if a drive is plugged in my only guess Is it’s a hardware or software issue with my PC now In other news I bought a new cable to see if that was the issue and the beeping stoped in the old one I have 0 idea what is going on
Update update tried a different port and I think it’s working?
If it’s in warranty, contact customer support. If not, take it out of the enclosure and try either connecting it to the PC or putting it in another enclosure. Hopefully you’ll be able to read it that way.